Rosslare AC-020 Instalační manuál stáhnout pdf (Strana 11)

Configuring the Reader

Swipe Family Readers Installation Manual Page 11

6 Configuring the Reader

To provide the highest level of security, the Reader is

programmed to validate only Mifare

cards whose settings

correspond to the Master card that is used to configure the

Reader. The Master card controls the following settings:

• Card transfer format

• Mifare card Key A value

• LED and buzzer control enable

• Lock-out settings

• Transmission of Card Serial Number (CSN) or card ID from

dedicated sector

Note:

The Master card is configured using the Desktop

Programmer (CP-R25). Refer to the AS-B01 SW manual for

more details.

6.1 Configuration Procedure

It is recommended to configure the Reader one time only,

immediately following installation.

To configure the Reader:

1. Power up the Reader. The middle LED lights continuously for

8 seconds of boot loading. Then 3 long beeps are

generated, and all 3 LEDs flash simultaneously for 3

seconds. The Reader is in Configuration mode.

2. Within 30 seconds (while the Reader is still in Configuration

mode), present a valid Master card to the Reader. If the

configuration was valid, 3 short beep will be emitted, and

all 3 LEDs will flash 3 times at a fast rate, simultaneously. If

the configuration was not valid, an error beep is

generated. The Reader is configured to operate according

to the settings of the presented Master card.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Žádné komentáře

Rosslare AC-020 Instalační manuál Strana 11